How do you tighten a boat throttle cable?

If there is a shifter issue in the motor, the throttle will have problems in the first half of its movement but not at the top since the shifter cable only moves when engaging gears. 90% or more of the time, stiff throttle controls are related to bad cables. If you need to replace one cable, change both.

If there is a shifter issue in the motor, the throttle will have problems in the first half of its movement but not at the top since the shifter cable only moves when engaging gears. 90% or more of the time, stiff throttle controls are related to bad cables. If you need to replace one cable, change both.

Also Know, should I leave my outboard motor up or down? Simply put, if you are leaving the boat in the water, leave it in the up position to avoid growth. If you are leaving it out of the water, trim it down to drain the water and protect the Power Tilt and Trim seals from the sun.

Likewise, how does a boat throttle control work?

The throttle control is a lever that can be pressed forward to increase the speed of the boat. When the throttle level is pushed forward, it opens the engine throttle in the outboard, which means that more air and fuel is being allowed into the combustion chamber at a higher rate of frequency.

How do you adjust the throttle cable on a Suzuki outboard?

Re: Suzuki Throttle Cable Adjustment Get a helper to push the throttle lever forward all the way and open the motor side up by hand, then tighten down the adjustment screw, then return it to neutral and make sure the throttle on the motor has relaxed all the way down to its resting position.

What is idle speed on a boat?

The signs read, “5 mph, No Wake,” not either/or. Most boats have two 5 mph speeds. The first, with the throttle clicked just forward of neutral, is called “idling in gear” — so that the engine is turning at around 600 rpm. The second 5 mph speed is the one in which the engine is turning about 1,300 rpm.

What is throttle friction adjustment?

An outboard motor’s forward and backward movement, including speed, is controlled by the throttle. The throttle control can be adjusted so that its friction makes operating the vessel comfortable and safe. It can also be adjusted, while operating the vessel, to change speeds.

What is throttle friction?

Throttle friction is exactly what it means. Tighten the knob and it increases the amount of force it takes to move the throttle.

How do you grease a boat throttle?

Pour enough motor oil into the bag to fully submerge the end of the cable jacket and zip the bag closed. Place a container beneath the bottom end of the cable to catch the oil that should eventually drip out of the lower end of the jacket. Allow the cable to hang until the oil drains through.

How do you unstick a throttle cable?

With the throttle control lever in the “choke” position, pull on the outer jacket of the cable near the clamp until the choke plate opens. Tighten the clamp with the cable in this position. Reassemble the air cleaner. If your lawn mower’s throttle cable is hard to move or stuck, here’s a fix.